Manual
Grease Pumps
Applications
This
pump meant for feeding grease to bearing and other moving part of
machine sand other lightly machines having 1 to 20 lubrication point.
Working
On
pulling the handle of pump, grease are sucked through suction port on
pushing handle of pumpt grease comes out under pressure through check
value. Spring pressure through follower plate exerted over the top
surface of the grease further helps to push the grease in suction port.
Equipment
Pump
is made up of purely transparent acrylic reservoir for storage of
grease. For sensing the Grease level a tell tale rod is provide and
follower plate assembly for help in positive suction of grease. It
contains two outlet part of 1/4" BSP right and left side in which one
is used as air bleed valve and second port used as a outlet. To check
reverse flow of grease, a non return valve is provide in the system of
the outlet port.
Filling
of Grease
Grease
can be filled manually or with another pump. Filling from pump 1/4:
part is provide. Manually, we have to remove follower plate, spring,
top cover and fill the grease from the top of the reservoir and to fit
all the components by pressure. For air removing unscrew the bleed plug
put the handle maximum out and press the follower plate by knob till
grease comes out from bleed plug.
Distribution
System
A
Progressive block is used to distribute the grease to the available
lubrication points in sequence one after another, Progressive Blocks
are added as per requirement.
Technical
Specifications
Model
|
Reservoir Capacity
|
Discharge
|
Maximum Pressure
|
Vertical Wall Mounting
|
MGP - 500 - 3
|
.5 kg.
|
3cc Per Stroke
|
70 kg./cm2
|
4 Holes, 7 Dia.
|
MGP - 1000 - 4
|
1 kg.
|
4cc Per Stroke
|
100 kg./cm2 |
4 Holes, 7 Dia. |
MGP - 1500 - 6
|
1.5 kg
|
6cc Per Stroke
|
120 kg./cm2 |
4 Holes, 9 Dia. |
|
